QuietStove® Forum
http://www.quietstove.com/forum/

Model 207 insertion force
http://www.quietstove.com/forum/viewtopic.php?f=4&t=625
Page 1 of 1

Author:  pcneal [ Fri Aug 31, 2012 3:23 pm ]
Post subject:  Model 207 insertion force

Just received my new 207 for my primus omnifuel. Works very well, and as expected very quiet. Is there anyway to make the 207 fit in the burner bell with a bit of resistance so that it does not fall out when the stove is packed?
Thanks,
Parris

Author:  quietstove [ Fri Aug 31, 2012 6:49 pm ]
Post subject:  Re: Model 207 insertion force

Hi Parris,

Once the stove is heated the QuietStove will tighten into the bell housing. Operate the OmniFuel on high for about two minutes and then let the stove cool down.

Let me know if that helps.

Craig

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/